top of page

Precision Detail


Please read the following statements and agree to the terms below



Information regarding

your vehicle wraps or graphics warranty and instructions of how to care for

them can be found on this page. If you have any questions, or a graphics

emergency, please contact us directly.




12-month warranty: covers peeling, excessive fading and


No warranty against peeling or abrasion on windows that move or

slide. We do not recommend opening windows that have window perf applied to


Typical life expectancy of perforated window film: 12-36 months.



12-month warranty: covers peeling, excessive fading and


No warranty on chrome, diamond plate or other metalized film.

Typical life expectancy of vehicle lettering: 3-5 years

depending on care and material type   (metallic, chrome and metalized

film have a shorter life: 1-3 years).



12-month warranty on installation and workmanship (peeling,

cracking or lifting). Damaged areas will be trimmed back, patched in, or

replaced if needed.

Typical life expectancy of a vehicle wrap: 3-5 years for

vertical exposure, 1-3 years for non-vertical exposure.




VEHICLE WRAPs for off road use

side by sides, atvs, dirtbikes, or any offroad race or recreation vehicle)

6-month warranty on

installation and workmanship (peeling, cracking or lifting). Damaged areas will

be trimmed back, patched in, or replaced if needed at owners expense.

These vehicles are typically

used in a manner that puts stresses and abuse on a vinyl wrap. These vehicles

have more exposure to high and low speed debris and exposure to rough surfaces

such as rock, stone, gravel and mud that will damage a wrap in a far shorter

period than standard daily driving.




6-month warranty: covers peeling, excessive fading and cracking. 

No warranty against peeling or abrasion on windows that move or

slide. We do not recommend opening windows that have graphics applied to them.

Graphics that are exposed to window wipers and not warranted for

peeling or abrasion.

Typical life expectancy for perforated window film: 1 year.


Damage caused from

vandalism, off-road use, wind, rain, hail, sleet or any act of God is not covered.





Graphics that are “RTA”

or “Ready to Apply” and are installed by the client are not covered against

lifting or peelings.

Warranty repairs will be done at Precision Detail's facility only.

Any altering or tampering with the graphics installed by Precision Detail will result in the

warranty being null and void.

No warranty is provided

if the graphic was aggressively washed or not washed properly (pressure

washing, automatic carwash).

No warranty is provided

from “wear and tear” (stone chips, dents, road rash or accidents).

No warranty is provided

if paint condition includes rust, rust bubbles, paint defects or clear coat


No Warranty is provided

if the graphic is being applied to stone guard film or paint.

No warranty on wrapped

door handles.

No warranty on wrapped


No warranty on wrapped

door jambs.


Removal of graphics prior to the end of the warranty period is

guaranteed not to damage OEM-painted surfaces. If graphics are removed

post-expiration of the warranty, there is no guarantee given for the surface

condition after 3 years.     

If surfaces are not covered with OEM

paint, no warranty is provided.

Tesla's are known for extremely bad paint from the factory that can easily peel off and

Precision Detail will not be held liable if paint peels off from install or removal.




The following

practices will help maintain the life and quality of the vinyl film:    

Wash applied vinyl graphics with a blend of clean water and a

mild care wash or detergent (i.e. Dawn®, Joy® or Ivory®).

Test any cleaning solution on a small section of the vinyl

graphic before using.

Always read the warning labels on car care products for proper

safety instructions.

Once you’ve washed the vehicle with a soapy water blend, rinse

with clean water.

Either let the vehicle air dry or dry off with a microfiber





Indications of vinyl

failure can include loss of gloss level, fading, cracking, chipping or peeling

around graphic edges. The following practices will result in deterioration of

the vinyl film:

Do not allow fuels to stay in contact with the vinyl for

extended periods of time. Clean all spills as soon as possible

Do not use automated car washes, truck washes using caustic

cleaners or pressure washers to clean your vehicle

Do not apply carnauba-based wax over vinyl graphic

Do not apply any type of wax or polish to matte or carbon

fiber-finished vinyl

Do not use mechanical brush washing





It is relatively

inexpensive to replace window graphics. Never compromise safety. Always ensure

maximum visibility.

Avoid using the rear windshield wiper and only use when

absolutely necessary, as it will scratch the laminate over time and reduce

visibility. It is best to clean any grime and sediment from your rear window

with a wet squeegee to avoid scratching

Avoid using your rear defroster, use only when absolutely

necessary as it can potentially reduce the lifespan of the see through

perforated window film

Avoid frequent rolling of windows with graphics in order to

avoid scratching

Do not use an ice scraper on any window that is covered with

vinyl specially perforated window film as it could scratch and damage the graphics

Keep in mind that

these are simple guidelines for extending the life of your window graphics. In

matters of safety, common sense should always prevail to ensure maximum

visibility at all times



No warranty of any kind if vehicle is pressure washed.



Spot clean the area with Isopropyl Alcohol and a microfiber rag.

Moisten a rag with a citrus-based cleaner and naphtha. Wipe down

the problem areas.

Immediately after using the citrus cleaner and naphtha, rinse the area with water and soap.

Paint Protection Film

  1. You authorize Precision Detail LLC and any staff to drive your vehicle in our parking area pertaining to pulling it into and out of our work bay.

  2. Paint defects such as rock chips , major scratches & other imperfections will still remain present on the vehicle. Depending on the severity of these defects they can sometimes appear more present after installation of PPF.

  3. You acknowledge that seams and / or relief cuts have to be placed in certain areas for correct film application and longevity.

  4. We do not wrap all edges, we will wrap edges that we know will hold long-term.

  5. Badges may or may not be removed and replaced. All badges will be cut around due to the ceramic coating properties of our particular film.

  6. Due to the difficulty of film installation and factors out of our control, you acknowledge that a few pieces of debris (including but not limited to; specs of dirt / fibers / hairs) could end up under the film, as well as some “work” marks are unavoidable depending on difficulty of your particular installation. These do not warrant re-application of film.

  7. Do not use a pressure washer to wash your vehicle unless you have discussed with us on how to properly use it with film being applied.

  8. Ceramic coatings & waxes may be applied after 30 days of installation. If a warranty claim becomes present Precision Detail cannot be held reliable for replacing your coatings , waxes etc.

  9. Film takes 30 days to fully cure, do not wash your vehicle for 1 week after film installation.

  10. Edges of the film should be regularly cleaned due to accumulation of dirt & debris on the edges. This is not considered a warranty issue.


—> PPF Removal <—

  • You agree not to hold Precision Detail responsible for any paint damage that may occur during the removal process.

  • PPF removal is charged hourly at a rate of $100 PER HOUR. (Minimum 1 HR)

  • No time frame can be given on removal.

  • By signing below, you agree to pay all charges in full associated with the removal of your PPF.


Window Film

  1. You authorize Precision Detail LLC and any staff to drive your vehicle in our parking lot pertaining to pulling it into and out of our work bay.

  2. Any old tint or adhesive will result in an additional charge. You will be contacted prior to Precision Detail proceeding.

  3. If you are scheduled as a drop off for the day appointment; The vehicle is left with us for the full day with no guarantee of completion time, other than end of our business day. Customer will be contacted once vehicle is completed. If you are not scheduled as a drop off for the day appointment, this line does not apply to you.

  4. MN legal limit for 2 and 4 door cars is: 50% all sides and rear. Trucks, SUV’s, Vans are: 50% front doors, and however dark you wish on the rear. (Crossovers are considered an SUV)

  5.  Visor Strips are considered windshield tint and are technically not allowed Per MN law, however we will tint down to the AS1 line. If an AS1 line isnt present we will not go any farther down than 8 inches as measured from the sides of the glass and the very top of the windshield glass down.

  6. MN legal limit for a full windshield is: NONE.  If windshield tint is applied there will be no warranty.

  7. A “perfect” match to factory-stained glass is impossible due to variations in glass and film color.

  8. If you wear polarized sunglasses you could potentially notice the aftermarket film differently than without your polarized sunglasses on.

  9. After film installation do not roll your windows down for 2 days - summer months / 5 days - winter months. Window film can take up to 7 days to fully cure.

  10. Any window which is below the legal limit for the state where the vehicle is registered, at time of installation, will receive NO RECEIPT OR WARRANTY.


  • *You may notice a slight low angle haze due to the IR coating on the film.

  • The IR coating on the film is not a defect.

  • Precision Detail will not refund your money OR replace the film with the same or a different series film.


  • Window film removal will consist of being steamed for removal.

  • Precision Detail cannot be held responsible for defroster wire damage.

  • Precision Detail will not be responsible for replacing your window.

  • *Customer will be contacted if the window film is not easily removed during the steaming process*.

Ceramic Coating

1. Do not wash your car with the use of any chemicals for 14 days from the coating application.

2. Do not use automatic touch car washes. Hand washing is recommended. Touch car washes will void any warranty and will be easily seen on a coating.

3. Automatic Car Washes can have chemical mixing malfunctions or will use a high PH bug remover which can change the properties of a coating including removing the hydrophobic properties, but it will not remove a coating.  If you have a high amount of bug splatter it is recommended to hand wash and use a PH Neutral bug remover or bring to Precision Detail for proper cleaning.

4. Do not let contaminants like bird droppings remain on any surface. You should remove them as soon as possible.

5. Do not expose to acid, caustic chemicals, and any other contaminants that you are aware of.

6. Follow the You Drive = You Care principal. Each Car is subject to a unique life. The harsher the life, the more maintenance it requires.

7. If any damage occurs, Contact Precision Detail, do not try to fix it on your own.

8. Always wash your car once it is cool and out of direct sunlight, never when the car is hot.

9. Ideally a vehicle should be washed every 2 weeks or 1,000 miles, whichever comes first.

10. Use good maintenance detail products like, Mothers CMX Wash, Americana SOAP, SYSTEMX Renew, Ceramic Pro Care Maintenance Products at least once a month.

11. Attend your yearly coating maintenance service every 12 months or 15,000 MILES

13. Damage due to the coating caused by misuse will not warrant replacement


1. When Dropping off a vehicle, scratches/swirls/rock chips or any damage may not be present until the vehicle is washed. Precision Detail will not be held liable for them.

2. Stains on the interior may not be fully removed due to the age and what made the stain. ( wine, koolaid, pop or food item)

3. Items that may already be broken or inoperable Ex. (window switches, electric running boards, climate controls) may not be noticed by Precision detail and Precision detail will not be held liable to replacing them.  


After the customer has signed this form and has had services completed but does not fully pay the balance due for services completed, A Mechanics Lien will be but onto the vehicle, preventing the sale of the vehicle in the future until payment is fully made to Precision Detail.  A 10% Annual Interest rate will be applied as well for any remaining balance not paid.

Precision Detail

Consent & Release Form


Thanks for submitting!

bottom of page